GenTent Open Frame Portable Generator Installation Videos

GenTent Direct Connect, Universal, and XL Universal Kits

Clamp It, Frame It, Cover It!

These videos demonstrate how to install the GenTent Direct Connect Kit, GenTent Universal Kit, and GenTent XL Universal Kit on open frame portable generators.

Follow each video in the recommended order to complete your initial installation. The series covers clamp attachment, frame rod setup, canopy installation, and apron connection, with best practices and part-specific guidance throughout.

Please Note: Our product may have changed since this video was made, and we are currently working to update this content.
Need help confirming your installation? Contact our support team. We're happy to assist.

Assemble your Clamp Hardware.

If you need help with the right position, enter your generator’s make and model at gentent.com/clamp-setting to get the exact clamp settings.

Set Your Clamp Rod Position.

If you’re unsure how to measure your generator perimeter, or need extra fitment guidance, please visit: www.gentent.com/fit

Install Your GenTent Clamps.

Install your GenTent Frame Rods.

Ensure frame rods are fully seated in the center connector to prevent tension-related damage or failure. See proper rod installation tips here .

Install the GenTent Canopy and Electrical Apron.

Does your generator have a blocked or obstructed frame?
Some generators may require a frame adaptation to install GenTent properly. This includes models with:
  • Muffler heat shields attached to the frame
  • Crossbars or panels blocking clamp access
  • Smaller frames between 76–80″ (standard) or 106–111″ (XL)
Refer to our Block Frame Addendum for guidance on how to adjust your setup.

Adapt Your Frame. Universal Frame Adapter (GTU) Installation.

Installing GenTent on a DuroMax generator?
Some DuroMax models feature inset electric panels or blocked corners that require slight clamp positioning adjustments:
  • Mount the clamp slightly higher where the panel is recessed
  • Continue with the standard installation after clamp setup
See the full DuroMax Fitment Addendum for step-by-step visuals and guidance.

Additional Helpful Tips

Some open frame generators require unique setups due to obstructed panels or oversized frames. View detailed installation guidance for select models below:

Specialty Generator Installation Guides

Refueling with the GenTent installed: You don’t need to remove the GenTent to refuel. Use the flap beneath the GenTent logo. View refueling guidance.

Register your GenTent: Activate your warranty and stay informed about product updates. Register here.

Need help? Browse our full support knowledge base at support.gentent.com.

!